How to use VVDI Prog and Xhorse VVDI2 Program Chevrolet ID46 Transponder

向下

How to use VVDI Prog and Xhorse VVDI2 Program Chevrolet ID46 Transponder

帖子 由 Admin 于 周一 十二月 25, 2017 4:09 am

VVDI Prog http://www.xhorsevvdi.com/wholesale/vvdi-prog-programmer.html read eeprom dump file,and VVDI2 transponder programmer http://www.xhorsevvdi.com/wholesale/xhorse-vvdi2-plus-vvdi-prog.html software program chip.



1.Start VVDI Prog software,choose EEPROM&Flash,and choose brand and chip in the software.



2.Check connection,and use EEPROM Clip Adapter.



3.After connect well,click read.



4.Read susccessfully,and then save the data.



5.VVDI2 Software,choose "Transponder Programming".



6.Choose "Special Transponder".



7.Choose "ID46 Chevrolet Circle Plus---PCF7936" type.



8.Put ID46 chip in the hole.





9.Click "Prepare".It shows prepare special key success.





10.Choose IMMO Data Tool.Then Choose Area/Factory/Car/Type.





11.Choose key information.Load eeprom dump file.Click make dealer key.





12.Prepare deal key success.It can start engine after write back new dump file or learn it to car.

Add another new key need load the new data file.Press OK to save the new dump file.



13.Start VVDI Prog software again.And click "Verify"



14.Press Open file save in VVDI2 new dump data.



15.Then click write.Click Yes continue to write,and after writing successfully,verify again.




Admin
Admin

帖子数 : 179
注册日期 : 17-03-28

查阅用户资料 http://xhorsevvdi.666forum.com

返回页首 向下

返回页首


 
您在这个论坛的权限:
不能在这个论坛回复主题